Flare Cap, 1/2"
S40-8
- For use with copper, brass, aluminum, and welded steel tubing that can be flared.
- Used extensively for connections of fuel, oil, air, liquid petroleum, and natural gas lines.
- Flare Fittings resist mechanical pull out
- Recommended for higher pressures than those covered by compression fittings
- Made to be assembled and disassembled over and over again
- Low Cost
- Reusable with a long or short nut
- Tramec Sloan manufactures brass fittings in the USA! Machined at our facility in Ohio, high-quality is guaranteed. Look for TS USA stamped right into the brass!
Body Material
Brass
Configuration
Cap
Fitting Type
SAE 45 Degree Flare
Tube 1
1/2 IN
CROSS REF
